NEC Univerge SV8100 Features And Specifications Manual page 1757

UNIVERGE SV8100
Program
Program Name
Number
25-07-02 System Timers for VRS/DISA –
VRS/DISA No Answer Time
25-07-03 System Timers for VRS/DISA –
Disconnect after VRS/DISA
retransfer to IRG
25-08-01 DISA User ID Setup – Password
25-13-01 System Option for DISA – VRS
Message Access Password
25-15-01 DISA Transfer Target Setup –
DISA Transfer Target Area at
Wrong Dial
25-15-02 DISA Transfer Target Setup –
DISA Transfer Target Area at No
Answer or Busy
31-02-01 Internal Paging Group
Assignment – Internal Paging
Group Number
31-02-02 Internal Paging Group
Assignment – Internal All Call
Paging Receiving
Voice Response System (VRS)
Description/Comments
If an Automated Attendant caller
dials an extension that does not
answer, the call waits this time
before rerouting to the Ring Group
specified in Program 25-03 and
Program 25-04. This time also
affects unanswered DISA calls.
Set the time for disconnecting a
call after it is re-transferred to a
ring group by VRS/DISA.
Set up password (six digits).
Enter the password DISA callers
must dial before the system allows
them to record, listen to or erase
VRS messages.
Used to assign a speed dial
number when the wrong number is
received.
Used to assign a speed dial
number when a dial tone times-out
and the target extension does not
answer or is busy.
Assign extensions to Internal
Paging Groups (i.e., Page Zones).
Allow/Prevent All Call Internal
Paging for each extension. If
allowed, extension can place and
receive All Call Internal Paging
announcements. If prevented,
extensions can make only (not
receive) All Call Internal Paging
announcements. If combined,
Paging zones should be restricted
as well. Change the internal page
zone group in Program 31-07-01
to 0.
Assigned Data
1
0~64800 (seconds)
(default = 0)
0~64800 (seconds)
(default = 60)
Dial (Six digits fixed)
#
(0~9, , )
(default not assigned)
#
1~9, 0, ,

Six digits fixed
(default not assigned)
Speed Dial bin number
0~1999

(default = 1999)
Version 3000 software
or higher is required
Speed Dial bin number
0~1999.

(default = 1999)
Version 3000 software
or higher is required.
0~64
(0 = No Setting)
Default:
0 for IP Station
1 for TDM Station
0 = Off
1 = On
(default = 0)
Issue 7.0
Level
2 3






2 - 1729