NEC Univerge SV8100 Features And Specifications Manual page 1706

Issue 7.0
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
10-26-04 IP System Operation Setup –
DT700 Peer to Peer Mode
14-02-10 Analog Trunk Data Setup –
Caller ID
15-03-10 Single Line Telephone Basic
Data Setup – Caller ID Name
20-08-15 Class of Service Options
(Outgoing Call Service) – Block
Outgoing Caller ID
20-09-02 Class of Service Options
(Incoming Call Service) – Caller
ID Display
20-19-01 System Options for Caller ID –
Caller ID Displaying Format (If
displaying digits are more than
12 digits)
2 - 1678
Description/Comments
Use to Enable (1) or Disable (0)
the Peer to Peer feature for SIP
MLT and SIP IP stations.
Enable/Disable a trunk ability to
receive Caller ID information.
Determine whether or not a single
line telephone should display the
Caller ID name.
Turn Off or On a user Class of
Service from automatically
blocking outgoing Caller ID
information when a call is placed.
If block is enabled, the system
automatically inserts the Caller ID
block code Q67 (defined in
Program 14-01-21) before the
user dialed digits (this requires
Program 14-02-10 to be enabled).
If block is disabled, the system
outdials the call just as it was
dialed by the user.
Turn Off or On the Caller ID
display at an extension.
Determine whether the first 10
digits or last 10 digits should be
displayed when Caller ID exceeds
12 digits.
UNIVERGE SV8100
Assigned Data
1
0 = Off

1 = On
(default = 1)
Trunks 1~200
0 = No

1 = Yes
(default = 0)
0 = Disable

1 = Enable
(default = 1)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On

(default = 0 for COS
01~15)
0 = First 10 digits
(Upper)
1 = Last 10 digits
(Lower)
(default = 0)
Voice Call Recording
Level
2 3

