Loading Fanfold Paper - Printronix L5000 Series Maintenance Manual

Loading Fan-fold Paper
To load paper, perform the following steps. Repeat this procedure whenever
top-of-form must be reset (e.g., after clearing a paper jam, loading new paper, etc.).
For details on clearing paper jams, refer to Chapter 7, "Troubleshooting."
This procedure assumes the following:
The power switch is OFF.
The power cord is unplugged.
The right rear cover is not attached.
The printer front upper cover is open.
You have installed the drum, developing unit, and toner cartridge.
1. Set the paper length adjustment on the power stacker (if installed) to match the
paper length to be used.
2. Set the paper mode on the power stacker (if installed) by pressing the HEAVY
key on the back of the stacker. ON equals "Heavy Mode" for thicker paper (LED
is lit); OFF equals "Normal Mode" for thinner paper (LED is not lit).
When operating the power stacker in Heavy Mode, the maximum stack height
following a cut or page eject depends on the page length, as shown in the
following table:
Page Length (inches)
3–18
7.0
7.5
8.0
8.5
9.0
9.5
10.0
10.5
11.0
11.5
12.0
Max. Stack Height (inches)
8.66
8.66
8.50
8.07
7.64
7.20
6.77
6.34
5.91
5.47
5.12
Consumables