Table of Contents
Advertisement
Device Check Menu
The device check menu allows for the operation of motors, solenoids, fans, lamps, and
the high voltage power supply. It reads sensors, encoders and input signals for the
transport unit, drum transfer cutter, developer waste toner clear, alarm circuits, and
switches. Figure 8–4 is an overview of the device check menu. Figure 8–5 through
Figure 8–9 show the more complex menu paths for output signal devices.
NOTE: Do not light the flash or halogen lamp continuously. Light it only once. If
DEVICE CHECK
OUTPUT
INPUT
SIGNAL
SIGNAL
TRANSPORT
UNIT
NEAR END
BACK FEED
PAPER OUTPUT3
PAPER OUTPUT4
NIP SWITCH
PAPER OUTPUT
PAPER OUTPUT1
PAPER OUTPUT2
TRANSPORT UNIT
COVER
MOTOR
COUNTER
SEPARATION CLAW
DRUM
CUTTER
FEED
GATE
MAGROLL
FACE
SLEEVE
TONER SUPPLY
CUTTER
DRUM COUNTER
Engine Checker
you are lighting the lamp more than once, turn on the Fuser R. Cooling Fan.
Otherwise, the fuser glass may break.
DRUM TRANS.
CUTTER
DRUM ENCODER
ELV. (UP)
ELV. (LOW)
CUTTER POSITION
CUTTER POSITION 1
FAN
SOLENOID
BLOWER
CLUTCH
HEAD COOLING
HEAD BLOWER
VACUUM
FUSER R. COOLING
Press
,
,
Press ENTER to select an option.
Press number keys to enter a value.
Press START/STOP to start/stop tests.
Figure 8–4. Device Check Menu
DEV. WASTE
T. CLR.
TONER EMPTY
TONER DENSITY
WAST T. BOTTLE SET
WAST T. BOTTLE FULL
DRUM CLEANER SET
LAMP
ERASER(LIGHT)
ERASER(HIGH)
PRE–HEAT
FLASH
to view options.
, and
ALARM
SWITCH
COVER
DIP SWITCH
HIGH VOLTAGE
ROTARY SWITCH
DRUM
FEED
HEAD TEMP.
HEAD TEMP. 1
LAMP TEMP.
FLASH
H.V.P.S.
DEV. BIAS
TRNS CHGR
SEP. CHGR
CLNNG BIAS
MAIN CHGR
PRE. CHGR
8–7
Advertisement
Chapters
Table of Contents
