Table of Contents
Advertisement
MESSAGE / PROMPT
ID MISMATCH
STAND-BY
WRITING TO DISK
BOARD REPLACED?
(Yes / No)
DISK REPLACED?
(Yes / No)
ORIG DSK AVAIL?
(Yes / No)
INSERT ORIGINAL
DISK & REBOOT
DRUM REV COUNT?
XXXXX
POWER ON HOURS?
XXXXX
ID MISMATCH ERR
CALL FOR SERVICE
4–8
Table 4–1. Page Counter Messages
EXPLANATION
The boot diskette used is either a new one or not the
one intended for this printer.
Wait for the system to complete disk writing. No action
is required.
Enter Yes if this is a new motherboard. Otherwise,
enter No. (Press NEXT or PREV to toggle between Yes
and No, then press ENTER.)
Enter Yes if this is a new diskette. Otherwise, enter No.
(Press NEXT or PREV to toggle between Yes and No,
then press ENTER.)
Enter Yes if the original boot diskette is available.
Otherwise, enter No. (Press NEXT or PREV to toggle
between Yes and No, then press ENTER.)
Insert the original boot diskette and reboot the printer.
Enter the value from the mechanical drum revolution
counter.
Enter the number of hours the printer has been powered
on (available from the latest configuration printout).
This message appears in the rare event that a failure
may have occurred in the printer. Call your service
representative to investigate.
Scheduled Maintenance
Advertisement
Chapters
Table of Contents
