Printronix L5000 Series Maintenance Manual page 67

4. Remove three screws on the upper inner cover. Then remove the cover.
The transfer charger must be in the down position to avoid scratching the drum.
Failure to perform steps 5 and 6 will damage the drum.
5. Check that the transfer charger is in the down position; if it is not, move it to the
down position by rotating the transfer elevator drive shaft counterclockwise.
Watch the charger movement:
a. If the charger starts to move up, it is already in the down position.
b. If the charger starts to move down, continue to rotate the drive shaft until the
Consumables
charger reaches the complete down position.
CAUTION
Transfer Elevator
Drive Shaft
Upper Inner Cover
Screws (3)
Transfer Charger
3–5