Menu Diagram
Printer Control
Surface Volts
*
Default is 580.
Range is 500
through 700 volts,
in increments of 4.
Cut–Sheet
Y Adj.
*
Default is 0/100".
(See Note 1)
Range is –100/100"
through +100/100", in
increments of 1/100".
Note 1: Default values will vary depending on
the factory settings on the inspection sheet
inside the printer. If there is no inspection sheet,
locate the serial number of the printer and
contact Printronix for the factory–set value.
7–12
Bias Volts
*
*
Default is 300 (or
Default is 25.00.
340 for new style of
corona power
Range is .25
supply).
through 50.00
msecs, in
Range is 200
increments of .25.
through 600 volts,
in increments of 10.
Fan–Fold
X Adj.
*
Default is 0/100".
(See Note 1)
Range is –100/100"
through +100/100", in
increments of 1/100".
Figure 7–2. Printer Control Menu
Cut–Sheet
LED Time
X Adj.
*
Default is 0/100".
(See Note 1)
Range is –100/100"
through +100/100", in
increments of 1/100".
Fan–Fold
Y Adj.
*
Default is 0/100".
(See Note 1)
Range is –100/100"
through +100/100", in
increments of 1/100".
Press UP, DOWN, NEXT, and PREV
to view options.
Press ENTER to select an option.
Press ONLINE at any time to exit
configuration (will save changes until
printer is turned off).
* = Factory Default
Reset
Toner Full
Press ENTER to
reset after replacing
a full waste toner
bottle.
Troubleshooting