Printronix L5000 Series Maintenance Manual page 316

TABLE NOTES:
1. For any error with Reprint on Fault enabled: If the printer stops while in the middle of printing a page,
reloading the paper and reprinting are required. There may be other cases requiring reloading and
reprinting; if so, a message will appear. It may be necessary to clear the paper path before reloading.
2. For any error with Reprint on Fault disabled: If the printer stops while in the middle of printing a page,
reloading the paper is required and pages are lost.
3. For error numbers 01, 14, and 15: If the error occurs while paper is not moving, it is not necessary to
reload or reprint.
4. For error number 02: If the error is caused by a paper–empty at the lower sensor (Paper Near End
Sensor), it is not necessary to reprint.
5. For error numbers 0C and 0D, verify that the transfer platform is completely seated. If errors reoccur,
contact field service.
Error
Code
01 Front Cover Open
02 Fan–fold Paper Empty
03 Paper Jam at Drum (B)
04 Paper Jam at Exit (D)
05 Paper Jam at Exit (D)
06 No Transfer Unit
07 Scuff Lever Open (knob "C")
08 Cut–sheet Path Open
09 Transport Motor Fail
0A Cutter Fail (front)
0B Cutter Fail (rear)
0C Transfer Platform Fail (upper)
0D Transfer Platform Fail (lower)
0E Paper Jam at Exit (D)
0F Paper Jam at Exit (D)
10 Paper Jam at Exit (D)
11 Paper Jam at Drum (B)
7–26
Table 7–1. Error Messages
Error Message
Operator Field Service
Correctable Required
See Note 5
See Note 5
Reprint
Required
See Note 3
See Note 4
Troubleshooting