4. Remove the photoreceptor drum. (Refer to page 3–31.)
5. Place the drum on a covered work surface.
6. If the drum is only slightly dirty, clean it with ethanol or iso-propyl alcohol. Do
not use acetone.
7. If the drum contains toner build-up, clean it with the drum refresher pad. Turn
the drum little by little while polishing the drum surface with the refresher pad.
Polish with a slight force in the direction of the drum axis, using a circular
motion. Let the polished areas slightly overlap each other, and polish the entire
drum surface two or three times.
Press lightly when polishing the drum surface, as too much pressure can damage
the drum.
8. Using the special dry tissue paper, thoroughly wipe the drum freshener off the
drum surface.
9. Wipe the drum surface again using a Toraysee cloth.
4–22
CAUTION
Scheduled Maintenance