Table of Contents
Advertisement
22. Remove the auxiliary rod from the drum shaft.
23. Reinstall the nut and tighten it securely by hand on the drum shaft.
24. Reinstall the drum plate and tighten the thumb screws. While installing the drum
plate, place your thumb over the copper grounding clip and hold it in place.
Otherwise the grounding clip can be bent, making no contact with the drum shaft.
25. After installing the drum, measure the resistance. Put the positive lead of a digital
multimeter on the edge of the drum, and the negative lead on the bracket on the
plate. Normal resistance should be 0Ω.
26. Reinstall the developing unit. (Refer to page 3–47, step 12. through step 15.)
27. Raise the transport unit. (Refer to Step 11.)
28. Reinstall the two inner covers and secure them with the screws.
29. Close the waste toner recovery unit and ensure that it latches.
30. Close the printer front cover.
Proper Disposal of a Drum Unit
Due to the nature of the material used in drum manufacturing, federal regulations
prohibit inappropriate disposal of laser print drums. Dispose of used drums by
shipping them to one of the following companies:
Within U.S.A.
U.S. Fuji Electric, Inc.
240 Circle Drive
Piscataway, NJ 08854
Attn: Rod Storm
Phone: (732) 560-9410
Outside U.S.A.
Fuji Electric GmbH
Mr. Takeshi Kusaba, President (Mr. Kazumasa Ozawa, Manager)
Lyoner Str. 26
D–60528 Frankfurt am Main,
Germany
Phone: (069) 669–0290
Fax: (069) 666–1020
Consumables
3–39
Advertisement
Chapters
Table of Contents
