Printronix L5000 Series Maintenance Manual page 306

3. Remove three screws on the upper inner cover. Then remove the cover.
The transfer charger must be in the down position to avoid scratching the drum.
Failure to perform steps 4 and 5 will damage the drum.
4. Check that the transfer charger is in the down position, and if not, move it to the
down position by rotating the transfer elevator drive shaft counterclockwise.
Watch the charger movement:
a. If the charger starts to move up, it is already in the down position.
b. If the charger starts to move down, continue to rotate the drive shaft until the
7–16
charger reaches the complete down position.
CAUTION
Transfer elevator
drive shaft
Inner cover (upper)
Screws (3)
Transfer charger
Troubleshooting