Table of Contents
Advertisement
4. Lower the transport surface by pressing down on the green lever on the transport
unit.
5. Loosen the two thumb screws on the right and left fuser unit holding plates.
Holding Plate
Green Lever
Thumb Screw
6. Grasp the handle and pull out the fuser unit until the second handle is visible.
7. With the other hand, grasp the second handle and remove the fuser from the printer.
8. Place the fuser on a clean, flat surface with the cover glass facing up.
CAUTION
Do not scratch the cover glass or place your hands directly on the cover glass.
9. Using the scraper, remove the dirt and toner build-up on the cover glass surface.
10. Wipe away any remaining toner or dirt with a Toraysee cloth.
Cover glass
Scraper
4–32
Scheduled Maintenance
Advertisement
Chapters
Table of Contents
