Table of Contents
Advertisement
Setup Safety Precautions
When installing the printer, observe the following setup precautions:
Printer
Do not operate the printer in a room that is not properly ventilated. The room
should be at least 1,000 cubic feet with complete air exchange every two hours.
Make sure nothing rests on the power cord. Do not locate the power cord where
people will walk on it. Do not place the power cord under any carpet.
Do not splash water onto the printer. This causes deterioration of internal
insulation, and creates a dangerous condition.
Do not place drinking cups or other objects on the printer.
Do not jostle the printer.
Do not let any metallic pieces (e.g., paper clips or staples) fall into the printer.
Do not turn off the power while the printer is printing.
Do not open the top cover while the printer is printing. This may cause a paper
jam.
Do not clean the printer while it is printing.
Do not use any flammable spray near the printer.
Consumables
Never stock the printer consumables –
Keep all consumables packed until they are to be used.
Read the installation instructions provided with each consumable.
1–4
Near an open flame
Where they may be exposed to direct sunlight
In an area that is hot and humid
In an area that is dusty and dirty
(See page A–8 in Appendix A, Specifications.)
Introduction
Advertisement
Chapters
Table of Contents
