Install Signal Cables
Now the printer can be connected to power and to the computer. To connect the
cables, refer to the illustration on the following page and perform the steps listed
below.
1. Verify that the site line voltage is the same as the voltage specified on the rear
side panel label. (Refer to "Power Requirements" on page 2–2.)
2. Make sure the printer power switch is set to 0 (OFF).
NOTE: To avoid possible electrical interference, separate the AC power cord and
3. Connect the free end of the power cord to the AC line receptacle.
4. Connect the interface cable to the appropriate printer interface connector and to
the host computer.
NOTE: The printer must be properly configured for the appropriate interface. Refer
2–12
the interface cable.
to Appendix F, Host I/O Interfaces.
Setup