Printronix L5000 Series Maintenance Manual page 328

5. Check the output paper sensor 2 (EPS2).
a. Connect the positive lead of the digital multimeter on pin 2 of CN7 on the
b. Push the EPS2 lever down and measure the voltage, which should be about
c. Raise the EPS2 lever up and measure the voltage, which should be about 0V.
If voltage is not normal, replace the EPS2 after checking the harness.
NOTE: Possible causes for an EPS1 (straight) paper jam:
NOTE: Possible cause for an EPS2 (cut–sheet face–down) paper jam: Paper may be
7–38
MPU board, and the negative lead on the SG.
5V.
Paper may be hitting the paper guide.
Paper may be hitting the ceiling cover on the exit side.
There may be too much paper accumulated in the output tray.
The solenoid actuator attachment may be defective.
jamming as it is moving from the main unit to the exit unit.
Troubleshooting