Unpack and Level the Printer
After a site has been selected for the printer, set up the printer according to the
following procedures.
1. Open the packaging, and unpack the printer and consumables, as described in the
Unpacking Instructions.
2. Using the casters, transport the printer to the location where it is to be installed.
Leave space around the printer when setting up, as shown on the previous page.
3. Using the height-adjusting legs, set the bottom of the printer 2.75" ±1//16"
(6.99 cm ± 0.16 cm) from the floor as shown below.
2–6
Height Adjusting Leg
Main Body Frame
2.75 in.
1/16 in.
(6.99 cm
0.16 cm)
Setup