Table of Contents
Advertisement
It is very important that the voltage is between the range listed in the chart. If you
cannot achieve this, call Printronix Technical Support for assistance.
9. Install the power supply unit cover.
10. Attach the right rear cover to the printer and tighten the screws. Insert the claws
into the centering slot so that the rear cover is set in place.
This completes the initial printer setup process. For printer configuration menus and
procedures, refer to the User's Manual.
Verify that the Paper Length and Paper Width options are set properly in the
Paper Control configuration menu.
Note that when you power on the printer, the following occurs:
NOTE: The printer can be set to power on in the OFFLINE state instead of the
In the event other messages and prompts appear on the control panel, answer the
prompts and follow the directions as explained in Table 4–1, "Page Counter
Messages" (in Chapter 4, "Scheduled Maintenance").
Consumables
The printer reads the emulation boot diskette and displays the message
"LOADING PROGRAM FROM DISK."
The printer retrieves font information from the diskette and displays
"LOADING FONTS FROM DISK."
The ONLINE indicator lights continuously and STAND BY goes out. (To
print, ONLINE must be lit; if it is not, press ONLINE.) The printer
automatically sets the physical top of form at the leading edge of the paper.
ONLINE state.
IMPORTANT
3–29
Advertisement
Chapters
Table of Contents
