OSI Security Devices OMNILOCK OM100 Series User Manual page 93

Press the number of each code group that you want enabled while at the
Code Required access level. If you want to enable all groups, press 5-ALL.
Press CL when you have finished selecting groups. Note: There is no
confirmation made for groups that you have selected until after you have
finished your selections.
If you press the CL key before making any selections, no changes will be
made to the Time Schedule and the event time prompt will reprint.
Otherwise, for each of the selected groups that contain a Supervisor code,
the following prompt will print in succession:
GROUP # n SUPERVISED?
1-YES 2-NO
Select 1-YES if you want the security level of the code group indicated by n
to be set to supervised. Otherwise, select 2-NO.
If you selected 1-YES, when you have responded to all of the required
prompts, a confirmation of the changes made will print and the event time
prompt will then reprint. The confirmation will be similar to the following:
ACCESS: C/R s + + -
Where C/R represents Code Required level and 's + + -' represents the
security level of code groups 1 through 4; (s) supervised, (+)
enabled/unsupervised, (-) disabled.
If you selected 2-NO to the Group #n Supervised prompts, a confirmation of
the group security levels will print and the event time prompt will reprint. .
The confirmation will be similar to the following:
ACCESS: C/R + + --
Where C/R represents Code Required level and '+ + - -' represents the
security level of code groups 1 through 4; (+) enabled/unsupervised, (-)
disabled.
Programming in Menu Mode
83