Placing Submaster Codes On Hold - OSI Security Devices OMNILOCK OM100 Series User Manual

------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Next, select 3-VERIFY from the Submaster Codes Menu:
- SUBMASTER CODES MENU -
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
A Submaster List report similar to the following will print:
---- SUBMASTER LIST ----
SUBMASTER #: MENU ACCESS
#502: ALL
#503: 1,3,4,5
#509: 1,2,3
------------------------
Note that for security purposes the PIN numbers for the assigned Submaster
codes are never printed. When the report is finished printing, the Submaster
Codes Menu will be reprinted.

Placing Submaster Codes On Hold

Programming Code Required:
Master Code
To place Submaster codes on Hold, select 2-CODES from the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 4-SUBMASTERS from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Programming in Menu Mode
71