Service Code; Adding The Service Code - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Menu Mode

Service Code

Adding the Service Code

Programming Code Required:
Master Code, or
Submaster Code with menu privileges 2-CODES
To add the Service code to the System, select 2-CODES from the Main
Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 2-SERVICE from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
52
------ CODES MENU ------
1-USER 2-SERVICE 3-AUDIT