Operational Control Features - OSI Security Devices OMNILOCK OM100 Series User Manual

or UNLOCKED
or LOCKOUT
or SHUTDOWN
All programming steps begin from the Main Menu. The Main Menu lists the
following options. To select an option, press the key corresponding to the
number of the option.
1-AUDIT (Select to print the Audit Log.)
2-CODES (Select to manage codes.)
3-ACCESS (Select to set the access level.)
4-SCHEDULE (Select to edit the Schedule or Holiday List.)
5-SETUP (Select to modify general settings.)
0-END (Select to end the programming session.)
Tip
To return to the Main Menu at any time while
in Menu mode, press and hold the CL key for
approximately 1.5 seconds.

Operational Control Features

End Command
Pressing 0 in response to any menu will cause the System to exit Menu
mode and terminate the programming session. (Note: Ending Menu mode
does not return you to Command mode. To return to Command mode, you
must reenter the Master code or the Submaster code and the desired
programming code.)
Keyboard Time-out
If a key is not pressed for approximately one minute, the System will
automatically exit Menu mode and terminate the programming session.
Because the System automatically ends a programming session after one
minute, you do not have to use the End command. However, because the
programming mode unlocks the lockset and the lockset remains unlocked
for one minute after you stop programming, we recommend that you use the
End command to end your programming session.
Programming in Menu Mode
33