Overview; New Features In Firmware Version 2.Xx; General - OSI Security Devices OMNILOCK OM100 Series User Manual

Chapter 1

New Features in Firmware Version 2.xx

A new User privilege, Manager, is available. A user with Manager
privileges can change or set any access level of the lock except
Shutdown. In addition the Manager may enable or disable specific
groups.
The Hold and Restore features for codes is now available in the
Menu Mode as well as in the Command Mode.
The procedure for assigning Supervisor privileges has been
changed in both the Command and Menu Modes.
A new Command Mode feature, ID Status Inquiry, has been added.
This feature allows you to determine whether a particular User
Code ID Number is currently in use, on hold or is unassigned.

General

The OMNILOCK Access Control System (the System) is a self contained,
electronically controlled, battery powered, single door access control
device. A keyless system, it has an 11-key pad on which access codes are
entered. A control module containing the System electronics, batteries, and
keypad, is coupled to a heavy duty lockset. A patented low-power
motorized locking mechanism in the lockset allows for years of reliable
operation on a single set of batteries.
To gain entry through a door secured with the Lock, a user enters an
individual code at the keypad. If both the access level and the code are valid
(i.e., the code entered exists in an authorized section of the Lock's code list)
the outside handle will unlock for a predetermined time, then re-lock when
released. The door can always be opened from the inside, regardless of the
locked status of the outside handle.
The System maintains an audit log of all System activity for later retrieval
by an administrator. The audit log stores the user ID, and the date and time
of each event. It even records unauthorized attempts to open the Lock!

Overview

1