If the Audit code is assigned, the following will print:
AUDIT CODE 511-1234
Where 1234 is the PIN assigned to the Audit code.
Otherwise, if the Audit code is currently on hold, the following will print:
AUDIT CODE ON HOLD
Otherwise, if the Audit code is not currently assigned, the following will
print:
AUDIT CODE UNASSIGNED
Once the status of the Audit code is printed, the Audit Code Menu will
reprint.
Placing the Audit Code on Hold
Programming Code Required:
Master Code, or
Submaster Code with 2-CODES menu privileges
To place the Audit Code on hold, select 2-CODES from the Main Menu:
)
------ MAIN MENU ------
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 3-AUDIT from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Next, select 4-HOLD from the Audit Code Menu:
--- AUDIT CODE MENU ---
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
Programming in Menu Mode
65