Syntax Conventions; General Programming Operation - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming Overview
Code Level Access/Programming Privileges
Master All times
Submaster All times except when the access
level is set to Shutdown;
Programming privileges may be
limited by the Master code
Manager All times except when the access
level is set to Shutdown
Supervisor Only when access level is Code
Required and user group is
enabled
General User
Only when access level is Code
Required and user group is
enabled and unsupervised
Service Only when access level is Code
Required and as allowed by the
Service Code Time setting
Audit No access privileges -
prints Audit Log only

Syntax Conventions

Syntax refers to the order in which you enter a command and any parameters
that follow it. You must enter each of the elements in the order shown in the
syntax line. In this guide, elements that appear in italic type are place-
holders and represent specific information that you supply. Elements within
brackets ([ ]) represent optional information. A plus (+) character separates
individual parameters within the syntax line. The + does not indicate that
you should enter the sum of the numeric values!

General Programming Operation

There are two programming modes supported: Command mode and Menu
mode. When in Command mode, the System will accept a single command
18
Programming Functions
All functions
All functions, if assigned, except:
1. Change Master code
2. Program Submaster codes
3. Set Shutdown access level
1. Can set the access level
2. Can enable or disable groups
Can set access privileges for
General Users in the Supervisors
home group to unsupervised
(allows access for General Users)
or supervised (denies access to
General Users)
No programming functions
No programming functions
No programming functions