Placing The Service Code On Hold - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Menu Mode
If the Service code is assigned, the following will print:
SERVICE CODE 510-1234
Where 1234 is the PIN assigned to the Service code.
If the Service code is currently on hold, the following will print:
SERVICE CODE ON HOLD
If the Service code is not currently assigned, the following will print:
SERVICE CODE UNASSIGNED
Once the status of the Service code is printed, the Service Code Menu will
reprint.

Placing The Service Code On Hold

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
To place the Service code on Hold, select 2-CODES from the Main Menu:
)
------ MAIN MENU ------
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 2-SERVICE from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
56