User Codes; Adding User Codes - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Menu Mode
The following events only print in the Audit Log if they were entered from
the Command Mode.
x x x x
xxx ADD
xxx HOLD
xxx RESTORE
SVC hh:mm

User Codes

Adding User Codes

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
To add User codes to the System, select 2-CODES from the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 1-USER from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
36
Group level(s) set (where x can be (+)
enabled, (–) disabled, (s) supervised)
Code ID xxx added
Code ID xxx placed on hold
Code ID xxx restored
Service Code Time set to "hh" hours and
"mm" minutes