Enter Menu Mode; End Programming Session - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Command Mode
To indicate the status of the User Code ID Number, the lights will flash as
follows:
Green
Green-Green
Green-Green-Green
Green-Red
Green-Green-Red
Green-Green-Green-Red
Red-Red-Red

Enter Menu Mode

Programming Code Required:
Master Code, or Submaster Code
To exit Command mode and enter Menu mode, enter the following
command sequence while in the Command mode:
Note: This command executes immediately, you do not need to press and
hold the CL key to enter it.

End Programming Session

To exit Command mode, enter the following command sequence while in
the Command mode:
Note: This command executes immediately, you do not need to press and
hold the CL key to enter it.
30
User Code is in use
Active Supervisor Code
Active Manager Code
User Code is on hold
Supervisor Code is on hold
Manager Code is on hold
Code ID is currently unassigned
99
000