OSI Security Devices OMNILOCK OM100 Series User Manual page 155

QUICK REFERENCE PROGRAMMING GUIDE
OMNILOCK ACCESS CONTROL SYSTEMS SERIES OM100, OM300 & OM500
To program the System in the Command Mode:
1. Enter Master or Submaster Code
(Press and Release CL Key to Extend Time-out to 1 Minute)
2. Enter Command from Below (Where Indicated with CL, Press and Hold CL
Key Until Lights Flash Result)
3. Repeat Step 2 as Required or Enter 000 when done
- Single Red Light Indicates Invalid or Unrecognized Command Sequence -
Function Command Sequence
Add or Change ID + PIN + CL
Code
Hold Code 86 + ID + CL
Restore Code 87 + ID + CL
Supervisor 88 + ID + CL
Privileges
Manager 89 + ID + CL
Privileges
ID Status Inquiry ID + CL
Set Access Level 90 + Level + CL
(Level = 1-Unlocked,
2-Code Required, 3-Lockout or
4-Shutdown)
To set Level 1 to unlock with first
code, continue to hold the CL
key until a second green flash
appears, (about. 1.5 seconds).
Enable User 91 + Groups + CL
Groups
Disable User 92 + Groups + CL
Groups
Service Code 94 + HH + MM + CL
Time Limit
Menus 99
Code ID Number Ranges:
001 - 100; 300 or 500 General User / Extended User Codes
501 Master Code
502 - 509 Submaster Codes
510 Service Code
511 Audit Code
(Firmware Version 2.xx)
Lights
G
R-R
R-R-R
G
G-G
R-R
G-G
R
G-G-G
R
G
G-G
G-G-G
G-R
G-G-R
G-G-G-R
R-R-R
G
G-G
G-G-G
G-G-G-G
R-R
G----G
G
G-G
R-R
G
R-R
G
R-R
N/A
Command Result
Code added
Code already in use
Code placed on hold
Code restored
Supervisor restored
Code already in use
Assigned
Invalid ID
Assigned
Invalid ID
User code in use
Active Supervisor code
Active Manager code
User code on hold
Supervisor code on hold
Manager code on hold
Code ID unassigned
Unlocked level set
Code Required set
Lockout set
Shutdown set
Invalid access level
Unlocked after first valid
code
Groups enabled
Groups enabled &
unsupervised
Invalid group number
Groups disabled
Invalid group number
Time limit set
Invalid time limit
* Requires printer