OSI Security Devices OMNILOCK OM100 Series User Manual page 54

Programming in Menu Mode
Next, select 1-USER from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
Next, select 6-GROUPS from the User Codes Menu:
--- USER CODES MENU ----
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-GROUPS 7-EXTEND
The following prompt will print:
STARTING ID (###)?
Enter the three digit code ID at which you want to begin assigning extended
group membership (you must enter any leading zeros) or press the CL key
if you are finished assigning groups. When you have entered a valid starting
ID number, the following prompt will print:
ENDING ID (###)?
44
------ CODES MENU ------
1-USER 2-SERVICE 3-AUDIT