where ID is the three digit code ID number to which you want to assign the
new code (you must enter any leading zeros) and where PIN is the PIN you
want to assign (it must be the same length as the current Master code PIN).
To indicate the status of your new code, the lights will flash as follows:
Green
The new code is set.
Red-Red
The code is already in use.
Placing Codes on Hold
Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
When a code is placed on hold, all access privileges for the code are
temporarily rescinded. The code is not removed from the memory of the
System and may be restored to full privileges with the restore command (see
below) at a later time.
To place a code on hold, enter the following command sequence while in
the Command mode:
where ID is the three digit ID number of the code that you want to remove
(you must enter any leading zeros).
To indicate the result of the command, the lights will flash as follows:
Red-Red-Red
The code has been placed on hold.
Programming in Command Mode
ID + PIN + CL
86 + ID + CL
23