Setting Group Boundaries - OSI Security Devices OMNILOCK OM100 Series User Manual

Next, select 3-DEFAULTS from the Setup Menu:
------ SETUP MENU ------
)
1-STATUS REPORT 2-CLOCK
3-DEFAULTS 4-AUTOCODES
5-RUN DIAGNOSTICS
Then, select 2-DAYLIGHT from the Defaults Menu:
)
---- DEFAULTS MENU -----
1-OPEN DELAY SECONDS: 02
2-DAYLIGHT: NORTHERN
3-GROUP BOUNDARIES
4-LOCATION: 123456
A prompt similar to the following will print:
)
DAYLIGHT: NORTHERN
1-NORTHERN 2-SOUTHERN
3-EUROPEAN 4-MANUAL
Select the desired Daylight Savings setting. When you have made your
selection, a confirmation of the setting will print and then, the Defaults
Menu will reprint.

Setting Group Boundaries

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 5-SETUP
A group boundary is the highest ID number within the code group. Use this
command to set the boundaries for Groups 1, 2, and 3 (the Group 4
Boundary is fixed at the maximum number of User codes for your System ).
To set the boundary of a selected Group, while in Menu Mode, press 5-
SETUP from the Main Menu:
) ------ MAIN MENU ------
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Programming in Menu Mode
99