Submaster Codes; Adding Submaster Codes - OSI Security Devices OMNILOCK OM100 Series User Manual

The following confirmation will print:
AUDIT CODE RESTORED
The Audit Code Menu will then reprint

Submaster Codes

Adding Submaster Codes

Programming Code Required:
Master Code
To add a Submaster code to the System, select 2-CODES from the Main
Menu:
) ------ MAIN MENU ------
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 4-SUBMASTERS from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
1-USER 2-SERVICE 3-AUDIT
------ CODES MENU ------
Programming in Menu Mode
67