Installing Batteries; Installing Paper - OSI Security Devices OMNILOCK OM100 Series User Manual

The WP4000 Printer

Installing Batteries

Remove the Battery Compartment Door from the rear of the Printer. Install
4 fresh 'AA' alkaline batteries in alternating directions, as marked in the
printer. Replace the Battery Compartment Door.

Installing Paper

Do not operate the Printer without paper. For best results, use Hewlett
Packard 82175 Black-Printing Thermal Paper (OSI part # WP106). Do not
pull on the paper -- use the Paper Advance Button. Do not pull the paper
backwards through the printer. Do not run the paper to the end of the roll if
the paper is attached to its inner core.
Tear or cut the end of a new roll of paper evenly at a slight angle. Do not
use paper with folds or uneven edges and do not allow obstructions to
contact the print mechanism.
Open the Paper Compartment Door and position the paper with the curl
facing up. The paper should feed from the bottom of the roll into the paper
slot. Slip the angled cut into the paper slot. While applying slight pressure
to the paper, press and hold the Paper Advance Button until the paper is
completely past the print head. If the paper jams, pull backwards very
slowly. Place the paper in the Paper Compartment and close the Paper
Compartment Door.
Important!
To avoid damage to the Thermal Print Head:
Do not operate the Printer without paper
Do not pull on the paper -- use the Paper
Advance Button
Do not pull the paper backward through the
Printer unless jammed
122