Setting the Location Number
Programming Code Required:
Master Code, or
Submaster Code with menu privilege 5-SETUP
The location is a 6 digit number that is printed in the log on header and on
most reports. It is used for relating the printouts back to the System when
multiple Systems are in use. It can be set to any value you like.
To set the Location number, while in Menu Mode, press 5-SETUP from the
Main Menu:
)
------ MAIN MENU ------
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 3-DEFAULTS from the Setup Menu:
------ SETUP MENU ------
)
1-STATUS REPORT 2-CLOCK
3-DEFAULTS 4-AUTOCODES
5-RUN DIAGNOSTICS
Next, select 4-LOCATION from the Defaults Menu:
)
---- DEFAULTS MENU -----
1-OPEN DELAY SECONDS: 02
2-DAYLIGHT: NORTHERN
3-GROUP BOUNDARIES
4-LOCATION: 123456
The following prompt will print:
6 DIGIT LOCATION?
Enter any 6 digit number you want to use as a reference for the System
printout. Once you have entered the number, the Defaults Menu will reprint
with the new Location number.
Programming in Menu Mode
101