Restoring The Audit Code - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Menu Mode
The following confirmation will print:
AUDIT CODE ON HOLD
The Audit Code Menu will then reprint

Restoring the Audit Code

Programming Code Required:
Master Code, or
Submaster Code with 2-CODES menu privileges
To Restore the Audit Code, select 2-CODES from the Main Menu:
) ------ MAIN MENU ------
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 3-AUDIT from the Codes Menu:
) ------ CODES MENU -----
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Next, select 5-RESTORE from the Audit Code Menu:
--- AUDIT CODE MENU ---
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
66