Programming In Command Mode - OSI Security Devices OMNILOCK OM100 Series User Manual

Chapter 6
To begin programming, enter the Master or a Submaster code. (As shipped
from the factory, the Master Code is set to 5 0 1 1 2 3 4 .) The lights will flash
3 times to indicate the battery level (see Batteries, page 105). If locked, the
System will unlock for access. To enter the Command Mode, press (and
release) the CL key or begin programming before the red light flashes to
indicate the end of the open delay time. The System will remain in the
Command mode for a minute after the last key that you pressed. This time-
out gives you the necessary time to decide what command you are going to
use next.
Tip
You have 5 seconds or the open delay time, if set
longer, to begin programming after entering the
Master or Submaster code. If you do not press a
key during this time, Command mode ends.
Pressing the CL key right after you enter the
Master or Submaster code extends the open
delay time-out to one minute for programming.
Because the System automatically ends a programming session after one
minute, you do not have to use the End command. However, because the
programming mode unlocks the lockset and the lockset remains unlocked
for a minute after you stop programming, we recommend that you use the
End command to end your programming session (step 5, below).
Note
Unless specified otherwise, a command is
completed by pressing and holding the CL
key until the lights flash (approximately 2
seconds).
Programming in
Command Mode
21