OSI Security Devices OMNILOCK OM100 Series User Manual page 73

Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
1-USER 2-SERVICE 3-AUDIT
Next, select 2-REMOVE from the Audit Code Menu:
) --- AUDIT CODE MENU ---
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
The following prompt will print:
REMOVE AUDIT CODE?
1-YES 2-NO
Press 1-YES to remove the Audit code. Otherwise, press 2-NO to abort
without removing the Audit code.
If 1-YES is pressed the following confirmation will print:
AUDIT CODE REMOVED
The Audit Code Menu will then reprint.
------ CODES MENU ------
Programming in Menu Mode
63