Verifying The Audit Code - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Menu Mode

Verifying the Audit Code

Programming Code Required:
Master Code, or
Submaster Code with 2-CODES menu privileges
To verify the Audit code setting, select 2-CODES from the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 3-AUDIT from the Codes Menu:
) ------ CODES MENU -----
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
Next, select 3-VERIFY from the Audit Code Menu:
--- AUDIT CODE MENU ---
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
64
------ CODES MENU ------
1-USER 2-SERVICE 3-AUDIT