OSI Security Devices OMNILOCK OM100 Series User Manual page 110

Programming in Menu Mode
Next, select 3-DEFAULTS from the Setup Menu:
------ SETUP MENU ------
)
1-STATUS REPORT 2-CLOCK
3-DEFAULTS 4-AUTOCODES
5-RUN DIAGNOSTICS
Next, select 3-GROUP BOUNDARIES from the Defaults Menu:
)
---- DEFAULTS MENU -----
1-OPEN DELAY SECONDS: 02
2-DAYLIGHT: NORTHERN
3-GROUP BOUNDARIES
4-LOCATION: 123456
Then, select the group number from the Group Boundaries Menu for which
you want to set the boundary.
)
--- GROUP BOUNDARIES ---
1-125 2-250 3-375 4-500
A prompt similar to the following will print:
GROUP 1: LAST ID (###)?
Enter the desired boundary for the specified group. When you have made
your selection, the Group Boundaries Menu will reprint and you may then
confirm the new setting.
Note
Adjusting the group boundaries may affect the
home group assignments of the underlying codes in
the code list. It is a good idea to print a Verify
User Report, with groups, after you have modified
the group boundaries.
100