General User Codes; Service Code; Audit Code - OSI Security Devices OMNILOCK OM100 Series User Manual

Access Levels and Codes

General User Codes

General User codes are for the day-to-day user. A General User code has
access at Code Required access level only. If the user code is within a group
that has a supervisor, access can be enabled or denied by a Supervisor (or
Master/Submaster if no supervisor is defined for the group).

Service Code

The System can be programmed with a single Service code for use by
persons who require access for a special purpose such as maintenance
personnel or vendors. This code has a limited life as set by an administrator.
The Service Code is valid from the first time it is used and can be used any
number of times during the life of the code (one hour as shipped from the
factory, refer to Setting the Service Code Time on page 59). When the
time expires, the Service code will automatically be placed on hold and you
must then restore or re-enter the code before it can be used again.
For example, the Service code could be set for use by a contract mechanical
engineer that needs access to a secured room to repair the air conditioning.
You might set the Service Code time for 2 hours which would allow the
contractor to enter and leave as many times as required during the 2-hour
time period.
The Service code may be used as a 'One-time' use code by setting the
Service Code Time to 00:00. When used in this fashion, the Service code
will be automatically placed on hold after its first use.
Conversely, the Service code may be made permanent by setting the Service
Code Time to 99:99. When used in this fashion, the Service code will
remain valid indefinitely.

Audit Code

The audit code is reserved strictly for printing the contents of the Audit Log
(requires the WP4000 wireless printer) This code does not open the
lockset.
7