Removing User Codes - OSI Security Devices OMNILOCK OM100 Series User Manual

Removing User Codes

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
To remove User codes from the System, select 2-CODES from the Main
Menu:
)
------ MAIN MENU ------
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 1-USER from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
-------- CODES MENU ---------
1-USER 2-SERVICE 3-AUDIT
Programming in Menu Mode
39