Assigning Manager Codes - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Menu Mode
Next, select 7-EXTEND from the User Codes Menu:
--- USER CODES MENU ----
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-GROUPS 7-EXTEND
The following prompt will print:
EXTENDED USER TYPE?
1-SUPERVISOR 2-MANAGER
Select 1-SUPERVISOR
The following prompt will print:
EXTEND USER ID (###)?
Enter the three digit code ID to which you want to assign Supervisor
privileges (you must enter any leading zeros) or press the CL key if you are
finished assigning Supervisor privileges. When you have entered a valid ID
number, a confirmation of the change will print and the above prompt will
reprint.

Assigning Manager Codes

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
To assign Manager privileges to an active User code, select 2-CODES from
the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 1-USER from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
50