Programming in Menu Mode
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
Next, select 5-RESTORE from the User Codes Menu:
)
--- USER CODES MENU ----
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-GROUPS 7-EXTEND
The following prompt will print:
RESTORE ID (###)?
Enter the three digit code ID that you want to Restore (you must enter any
leading zeros) or press the CL key if you are finished restoring User codes.
When you have entered a valid code ID number, confirmation of the change
will print and the above prompt will reprint.
Assigning Supervisor Codes
Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
48
------ CODES MENU ------
1-USER 2-SERVICE 3-AUDIT