Verifying User Codes - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Menu Mode
Next, select 2-REMOVE from the User Codes Menu:
--- USER CODES MENU ----
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-GROUPS 7-EXTEND
The following prompt will print:
STARTING ID (###)?
Enter the three digit code ID at which you want to begin removing codes
(you must enter any leading zeros) or press the CL key if you are finished
removing User codes. When you have entered a valid starting ID number,
the following prompt will print:
ENDING ID (###)?
Enter the last three digit code ID that you want to remove or, if you are only
removing a single User code, press the CL key and the System will accept
the starting ID number that you entered above as the ending ID number.
When you have entered a valid ending ID number, the System will prompt
you for confirmation before removing the specified block of User codes
such as follows:
REMOVE USERS 100-300 ?
1-YES 2-NO
Select 1-YES to remove the specified block of User codes. Select 2-NO to
abort without removing codes. Once you have made your selection and if
any codes were removed, a confirmation will be printed. The starting ID
prompt will then reprint.

Verifying User Codes

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
To verify User codes (print a list of assigned codes), select 2-CODES from
the Main Menu:
40