Setting The Service Code Time Limit - OSI Security Devices OMNILOCK OM100 Series User Manual

Setting the Service Code Time Limit

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
The Service code time limit defines the length of time that the Service code
remains active after its first use. To set the Service code time, select 2-
CODES from the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 2-SERVICE from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
1-USER 2-SERVICE 3-AUDIT
The current setting for the Service Code Time Limit is displayed in
parentheses immediately following the 6-TIME LIMIT option on the
Service Code Menu.
------ CODES MENU ------
Programming in Menu Mode
59