Code Required - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Menu Mode
When you have responded to all of the required prompts, a confirmation of
the changes made will print. The confirmation will be similar to the
following:
ACCESS: U/C s + + -
Where U/C represents Unlock with Code level and 's + + -' represents the
security level of code groups 1 through 4; (s) supervised, (+)
enabled/unsupervised, (-) disabled. The Main Menu will then reprint.
If you selected 2-NO to the Unlock With First Code prompt, the following
confirmation of the change will print and the Main Menu will reprint.
ACCESS:
UNLOCKED

Code Required

If you selected 2-CODE, the following prompt will print:
SELECT GROUPS TO ENABLE
)
(1-4, 5-ALL, CL-DONE)?
Press the number of each code group that you want enabled while at the
Code Required access level. If you want to enable all groups, press 5-ALL.
Press CL when you have finished selecting groups. Note: There is no
confirmation made for groups that you have selected until after you have
finished your selections.
If you press the CL key before making any selections, no changes will be
made to the access level and the Main Menu will reprint. Otherwise, for
each of the selected groups that contain a Supervisor code, the following
prompt will print in succession:
GROUP # n SUPERVISED?
)
1-YES 2-NO
Select 1-YES if you want the security level of the code group indicated by n
to be set to supervised. Otherwise, select 2-NO.
78