Note
Before assigning Supervisor Codes, the System
should have been through an unlock and lock
cycle.
Otherwise the Access Level will be
incorrectly reported until the Access Level is
Subsequently changed manually or by the Time
Schedule.
To assign Supervisor privileges to an active User code, select 2-CODES
from the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 1-USER from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
1-USER 2-SERVICE 3-AUDIT
------ CODES MENU ------
Programming in Menu Mode
49