Wall Mount System (Non-Weatherized) - OSI Security Devices OMNILOCK OM100 Series User Manual

Batteries

Wall Mount System (Non-Weatherized)

CAUTION
Use electrostatic discharge protection procedures
when the printed circuit board is exposed.
Step 1 Insert the key into the Cylinder Assembly and rotate it
counterclockwise until the Cylinder Assembly can be removed from
the Module (Figure 8) .
Step 2 With your finger, reach into the hole in the Module and guide the
wires out through the hole. Make a note of how the wires are
connected and then disconnect the wires.
Step 3 Remove the two Mounting Screws and remove the Module from the
wall.
Step 4 Using the tab on the Battery Cover, carefully pull the Battery Cover
away from the Housing to expose the Batteries (Figure 9)
Step 5 Remove and replace each of the old Batteries, one at a time, with the
plus (+) end down.
Step 6 Close the Battery Cover and press the Gasket in place.
Step 7 Remount the System in the reverse order of Steps 1 through 3 and
you are done!
112