Programming in Menu Mode
If you want to change the Time Limit, select 6-TIME LIMIT from the
Service Code Menu:
-- SERVICE CODE MENU ---
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-TIME LIMIT (01:00)
If you select 6-TIME LIMIT, the following prompt will print:
SVC CODE TIME (hhmm)?
Enter the new Service code time limit as hhmm, where hh is hours in the
range 00 - 99 and mm is minutes in the range 01 - 59. (You must add a
leading 0 for hours and minutes less than 9, e.g., 0507). The System ships
from the factory with the Service Code Time set to one hour (0100).
Note
Setting the Service code time to 00:00 provides a
'One-time' use code.
Setting the Service code time to 99:99 will allow the
Service code to remain valid indefinitely.
Once you have entered a new Service Code Time Limit, the Service Code
Menu will reprint. You can then verify the change by observing the new
time limit displayed.
Audit Code
Adding the Audit Code
Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
60