OSI Security Devices OMNILOCK OM100 Series User Manual page 68

Programming in Menu Mode
Next, select 2-SERVICE from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
Next, select 5-RESTORE from the Service Code Menu:
-- SERVICE CODE MENU ---
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-TIME LIMIT (01:00)
The following confirmation will print:
SERVICE CODE RESTORED
The above prompt will then reprint.
58
------ CODES MENU ------
1-USER 2-SERVICE 3-AUDIT